إسأل Mechanical Engineer الآن
Mohamed Saleh
Mechanical Engineer
الأسئلة المجابة 44982 | نسبة الرضا 98.8%
hi sar i have mustange 2014 and i have problam...
إجابة الخبير: Mohamed Saleh
Mohamed Saleh
Mechanical Engineer
الأسئلة المجابة 44982 | نسبة الرضا 98.8%
Welcome, and thank you for trusting us
P0018 in ford mustang is a diagnostic trouble code (DTC) for Crankshaft Position , This can happen for multiple reason as follows :
The bank 2 intake camshaft is out of position compared to the crankshaft position.
The bank 2 camshaft phaser is stuck in one position or will not move.
The phaser is not getting oil because the oil viscosity being used in the engine is too thick.
The Oil Control Valve (OCV) is stuck closed or open mechanically
To solve the problem do the following :
Checks for problems with connections or wiring for the OCV and camshaft sensors.
Checks the engine oil to make sure that the correct oil is being used.
Scans the engine codes and views the freeze frame data to see when the code was set.
Clears the codes and then road tests the vehicle, simulating the freeze frame failure to duplicate conditions of when the last failure occurred.
Turns the OCV on and off for the bank 2 camshaft and monitors the camshaft sensor for changes in the timing
I highly recommend you to make a phone call to me. In cases like yours, I found that phone calls helped much in clarifying the legal status in details. If you would like, you can make a phone call to us. It will cost you a little. Please click on the link below.
jawabkom.com/36174359
Kind Regards
Engineer mohammad
إسأل Mechanical Engineer
Mohamed Saleh
Mechanical Engineer
الأسئلة المجابة 44982 | نسبة الرضا 98.8%
- 100% ضمان الرضا
- انضم الى 8 مليون من العملاء الراضين
