47 Tender 2uz V8 engine, changed timing belt,...

Our dear customer, regarding your question about adjusting the engine cylinder in your car, we advise you to do the following:
1- Go to pin 19, which is the dynamo’s screw, and unscrew it so that you can ventilate it on its belt for easy removal. Here, for safety, disconnect the dynamo’s power cord in case anything happens. 2- Get a regular screwdriver and place it under the belt (the belt), where it is inserted from the bottom of the tambour of the water pump. Raise it very slightly and put the car in fourth gear and push it slightly forward, allowing the belt to come out of the tambour. 3- After completing the disassembly of the belt, we go to remove the pump screws, which consist of four 13 screws. Start unscrewing one nail quietly and do not put pressure on the nails so as not to miss them. If the nails are hard while removing them, do not press in the removal, just click. Use it lightly with your hand until the screws are loosened. In removing these screws, you may be able to remove the first three more easily than the fourth screw, if its place is a bit difficult, and to remove it, you will need to remove the 17th motor base screw, and using the cork, raise the motor, then bring a wooden block and place it on the The plug is so that it is mounted on the oil tank, and be careful to use the wood so that it does not affect the oil tank. Then you can reach the remaining screw and unscrew it. To remove it, you will need a 13-serrated wrench so that you can unscrew it. 4- After completing the removal of the four screws of the pump, the pump is now ready to be removed from its place, but you will not be able to remove it easily because it is attached to silicone, so bring a heavy hammer or something that is called a hammer and tap on it lightly and it will begin to be removed from its place and thus we will be We have finished removing the old, damaged pump from its place, and you will notice how bad its shape is and how rust has accumulated and corroded on it. 5- Clean the place of the old pump, that is, clean the outer lip using a putty knife or a regular screwdriver to work on scraping off the rust or any deposits on it. Make sure during the cleaning process that you are able to remove the old gasket that is stuck to the lip, so sand it lightly using fine sandpaper until it Do not damage the lip and have to replace it. The important thing is to ensure that the old gasket is completely removed. 6- Get the new gasket, which comes with the new pump. Then you bring thermal silicone, which you apply to the lip of the pump. Place the new gasket and secure it. Then place the silicone on the walls, then press the pump in the place designated for it. 7- Finally, re-tighten the pump screws, install the dynamo belt in the place designated for it, tighten it, tighten its nut, remove the cable, return the machine to its place, fasten the motor base screw, and reinstall the electricity wire in the end.